AC30 + AC15 in parallel with my signature 15ms simple delay which massively increases the stereo image.

This preset is designed to integrate into your existing pedalboard as a direct solution with a couple extra effects if you want to use them. It will work well at the end of your pedalboard as a clean amp + a couple extra effects, or between your wet and dry effects, enabling you to effectively use the “amp drive” switch (footswitch 1).

Footswitches:

1. Amp drive up/down: go from edge of breakup to cranked. Place your wet effects in Stomp’s loop after the amp/cab/eq blocks (or after the Stomp altogether), and use this footswitch to eliminate the need for expensive transparent overdrives.

2. Toggles the decay and mix on the reverb block.

3. Single coil / humbucker switch. LED off = single coil, LED on = humbuckers. Toggles some amp settings to maximize flexibility with different guitars and pickup configurations. In order to access this switch you will need to go to the global settings and set FS3 Function to “Stomp 3.”

4. Clean Boost (use a two button TRS footswitch to gain access to fs4 and fs5 on Stomp).

Important note for users running mono: Bypass or delete the delay on path 1B in order to avoid phase cancellation when the two stereo amps are summed to mono.

Please read the HX Stomp notes on the main HX Stomp page for recommended settings, placement, usage, etc.

Recommended IRs: All my presets come ready to go with stock cabs and all the demos are tracked with the presets as they come out of the box. IRs are not necessary to get good tones, but if you would like to use IRs, simply replace the stock cab blocks with 1024-sample IR blocks and load up the IRs below. I would start with the OH1 quick start mixes from ownhammer’s $29 Vox pack. Try the green cab on one and the blue on the other. I also like the cream and gold options, and I really like the M+ options for live playing.