FM9 Turbo + Firmware 12 or later required. This preset has the new AC30 Brilliant amp model and the Deluxe Reverb Vibrato channel hard panned left/right.

Per preset footswitches:

1) Tap/Hold Drive 1 channel increment/decremoent (A-D have increasing amounts of gain). These 4 channels are my stage 1 drive sounds

2) Drive 1 on/off

3) Drive 2 on/off - Hold to toggle between channels A-B. A is a Klon, B is a 1981 DRV (rat mod). Can be stacked or used standalone. I’ll usually stack the klon with Drive 1 for leads, but I use the 1981 standalone

4) Tap/hold Plex verb channel decrement/increment. Similar to the BigSky Bloom mode. This is the “worship reverb” sound. Channels A-D are have increasing decay+mix settings

5) Toggle between Plex Verb and Standard reverb block, all with tails

6) Tap/hold Reverb 1 channel decrement/increment

7) Tap: Pitch 1 on/off. Hold: Pitch 1 channel increment

8) Post amp clean boost

9) Tap: Trem 1 on/off. Hold Trem 1 channel increment.

10) unused

11) Tap/hold: Delay 1 channel increment/decrement

12) Tap/hold: Delay 2 channel increment/decrement

13) Delay 1 on/off (1/8th note)

14) Delay 2 on/off (dotted 8th note)

15) Toggles Delay 2 between dotted 8th and dotted 16th notes.

Setup Notes:

Please use the PER PRESET footswitch layouts to access all the per preset footswitch assignments. You can find my FM9 layouts here.

I highly recommend setting the footswitch hold timeout to 0.5 seconds in the global settings for extremely fast hold functionality.

Mono users: This preset has a massive stereo image but is mono-compatible, just bypass the Enhancer block. In order to get the sound of both amps to FOH, in your global settings navigate to I/O > Audio Tab > “Output 1 Configuration” > Mode, and set it to “SUM L+R”.